[Dusters]

Does anyone have a walk around to get the BCM to sync with the monitor on days it won't connect?

Back info: Power gen running (10.7 VDC min rqd), sync'd up to extend two of the electric slides, 15 minutes later no BCM sync. Powered down (computer reboot theory) several times and after another 20 minutes or so went to the manual switches on the board to close up the unit. The Red LED stayed on at the module, if I recall a blue LED should appear when sync'd.

This tends to happen about once a year and then just works after a little patience. The board was replaced last year while at the dealer for it's annual physical. I'm guessing for an industry post or recall.