View Single Post
Old 08-15-2017, 08:16 AM   #6
kdeiss
Montana Master
 
Join Date: Feb 2003
Location: Englewood
Posts: 3,090
M.O.C. #164
As mentioned above just use a screw driver between the valve and the flange the valve all you need is maybe a 1/4 inch of movement. I suggest putting a dab of Silicone on rubber gaskets before installing to keep them in place not rocket science I have replaced many. Getting the rubber gaskets in place is crucial otherwise you are going to have a leaker do not over tighten the bolts
kdeiss is offline   Reply With Quote