[jcurtis934]

Yes, the tanks have a molded in number on them. Had two breaks on our galley tank, the top rim split and the bottom cracked. Plastimend repair still as good as the day I did it. Galley tanks are somewhat a pain to drop as you have to cut the drain inlet pipe couple of inches above the floor under the sink or wherever you see it going through the floor. Rubber no hub coupling will be used to reconnect it. With outlet also disconnected and wires for level removed...it only requires removal of the square steel tube holding one top lip, then thetilt down on that side to get the drain pipe through the floor, and then pull it sideways to get the other lip out from under the other support. Couple days to do the repair/s, time to figure out how to get some support around the tank after re-install, and voila...back in business.