[scottz]

Ok Keystone, here is another one. How about doing a better job attaching the aluminum skirting to the frame? My rig was less than six months old when the skirting on the rear started ripping off. I took a look at the skirting on both lengths of the rig and found several screws missing and on some the aluminum had pulled through the head of the screw because no washers were used. I also found a couple where the screw had been driven in totally missing the aluminum. Did you do this in the dark? How about a little quality control?

I fixed your poor workmanship by using new screws and washers down both sides of the rig.