Thread: Water Pump
View Single Post
Old 09-13-2018, 02:57 PM   #11
Texan
Montana Master
 
Join Date: May 2017
Location: new caney
Posts: 1,050
M.O.C. #19873
I just changed my water pump to the Shur-Flo 4008 and also installed a silencer on the water line. There is no comparison between the old and new pump. I can't tell if the silencer or pump did the most good or both but for 86.00 and about an hour of work i reduced my noise at least 80 or 85 percent. I do not have any more hammering and buzzing sound as before. It is slightly more quite with the shroud in the convenience center off than on. This is probably because the shroud is very thin so there is a little echo of noise. . I'm going to glue a 1/2'' thick piece of styrofoam to the shroud and that should take care of a little more noise. If i had known this worked this well then i would have done this a long time ago. This mod is no gimmick.
Texan is offline   Reply With Quote