|
...
Have starboard side done. Pretty straight forward. Did not replace bearings, did clean everything good and put new Red Line grease in. Replaced all bearing seals. Front starboard had grease on pads. Have not found electrical problem, hampered by my own ignorance. Looks like power comes from front down port side on two separate lines (2 lines w/2 wires each). First line exits underbelly via slit, goes to front brake, then inside axle to front starboard side. Other wire goes to rear port, then inside axle to rear starboard side. Question: How do you recommend I check for power? How many volts should there be? Thanks, Steve
__________________
 2010 Montana Mountaineer 295RDK
2007 Ford F-250 Tires, outside exhaust, and other things."We all are eternal spirits; and at the end of what we now see and experience, eternity begins, which is reality." SD Shaffer
|