View Single Post
Old 11-27-2017, 02:32 PM   #104
mtlakejim
Montana Master
 
mtlakejim's Avatar
 
Join Date: Oct 2017
Location: Bee Branch
Posts: 1,596
M.O.C. #20693
Hmmmm good point. What if you drilled the hole on the underside of the "L" shape and used a long shank lock over the top of the bar so you didn't have to drill the handle itself? Also the hole could be a lot smaller?


Or maybe use an eye bolt on the bottom mounting hole and fabricate a metal latch that would wrap over the top of the handle? I can weld, let me study on that subject a bit and get back to ya on it. If I decide to go that route I can make two of them if ya want one?
mtlakejim is online now   Reply With Quote