[mjammersc]

I am wrapping up a couple last minute details before I start my solar install. I am using a Magnum MS2812 inverter and was wanting to feed it in their "dual in-dual out" config where you route 2x30A breaker/feed into the inverters transfer switch circuit and then it routes the 3x30A to the sub-panel. My power center can't handle more than a 20A per spec so I am looking at options. One is setting up a new main panel sim-to BigBoomers setup that can handle the 2x30A breaker and moving my AC breakers to this panel. I was wondering if there was any other options/suggestions to reduce the amount of rewiring and space taken up by putting in 2 AC panels (new main and a sub). Is tying into the main 50A incoming and running into something like a MidNite BabyBox with a 2x50 or 2x30A input and then a 2x30A out doable? Other ideas?

Thanks for any suggestions