Quote:
quote:Originally posted by bncinwv
I am trying to remember when the change occurred but there was a change from gen-set ready to gen-set prepped that were two totally different things. Gen-set ready (I think that is the designation Montana used) meant that the entire system, switch, transfer switch, and all wiring were installed and all that needed added was the genny. Later years were gen-set prepped which only provided the control wiring that was needed for the installation. All other items had to be purchased separately. If there is a control wire (thin) from the front of the rig to the battery compartment, then most-likely there was not a transfer switch installed. I think that this change occurred in the 2008-9 timeframe. Our 2007 model had the transfer switch mounted on the back wall of the battery compartment.
Bingo
|
This info applies to our unit. Thin wire to battery and nothing on back wall in compartment matches our specs. I see nothing that even looks similar to a switch box. I am familiar with the change-over boxes from previous m/h I owned.
Thanks Bingo.