Quote:
quote:Originally posted by cbgaloot
Great job Senior Chief.
How did you attach the supports to the walls? I'm a bit shy about nails or screws.
|
For the supports in the upper cabinet, I used 3/4" long screws (2 in each rail/bracket) screwed into the 3/4" inch square posts in each corner of the cabinet. I had to add one 3/4" square, 18" tall post to the back left side of the upper cabinet which I attached using 1 1/4" long countersunk wood screws which screwed into the 3/4" post of the adjoining cabinet. I could have used construction adhesive for this just as well.
For the cabinet at the end of the kitchen counter, I used one 1" long screw into each of the three 3/4" square posts leaving about 1/4" of the screw exposed for the three sides of the shelf to rest on.
If any of this is unclear or photos are needed, let me know.
Jack
__________________
Previous:2004 Mountaineer 325FKBS,2010 Montana 3455SA Now:2018 Bighorn 3575EL (SOB's ) Res. Fridge,W/D,Disc Brakes,Water Softener,Dish Tailgater PRO,LioN Batts, several mods.
2021 RAM 3500 Laramie.... "LOADED", 4x4, SB H.O. 6.7L, Aisin Trans, PullRite Super Glide Hitch, 52 Gallon Titan Fuel Tank.
|