Quote:
|
quote:Also, the mounting bolts to go through the telescoping rear stabilizers are supposed to replace the bolts holding the footpad. But they're not long enough for our stabilizers. So, CW drilled a hole in the sheetmetal of the side rear stabilizers and bolted the mounts through that hole. I'm not sure that sheetmetal doesn't flex with pressure. I'm going to go to Lowe's and get couplers, studs, washers and nuts and do it the right way.
|
Steve - I have the JT's and in response to the bolts bending on the rear stablizers, I called and spoke with the owner/designer of the JT's. He suggested to drill a hole about an inch above the bottom foot pad bolt and install the JT bolt in this new hole.