If you have basic electronic skill sets and can follow this pin out of the BCM it would be real easy to simply pick up DC power from pin 80 on BCM and using a jumper wire with clip on remove output wire from BCM source Device you want to run and provide power to it.
This would be an emergency use only if you were away from any cell service and internet and local help
If your slides are hydraulic the manual over ride buttons on BCM will do NOTHING for your slides or hyd levelers. You will need cordless drill with 1/4 inch Allen stock and 1/8 inch Allen wrench to manually operate hyd pump and open solenoid valves ... period
HVAC and furnace will be dead since you have no way to easily communicate across the CANBUS to provide data to control module for Zone 1 or Zone 2 as well as no furnace
|