Quote:
Originally Posted by mainer
1retired06
This is great to hear, it is so difficult to open and close ours. Where did you purchase the direct pulls?
Thanks for the info.
|
Valterra. On my rig, I pulled down the underbelly, rerouted some plumbing lines, using home depot materials including two rubber couplings, which will make it easy to change gaskets if required. Had to redirect the two pull locations in the convenience center, black to DS frame, gray to ODS frame, plugged the cable holes in the convenience center with rubber plugs. The other two pulls were located behind a flip door on the ODS side, and I was able to leave those two pulls in the same location within inches. Five hours on a Saturday, another hour following Sunday afternoon to reinstall the belly. I found all four cables to be way too long, with many kinks and bends. After fighting cable pulls for years, and immediate failure on the 3910 I decided I had had enough. Way cheaper than going electric.