THANK YOU John!! 
Quote:
quote:Originally posted by H. John Kohl
I replaced the fuse with a 40 amp resettable breaker.
However if you are blowing fuses that often when unhooking I suggest you check for proper lubrication and more important possible binding.
I suggest you pop the cap of each leg in the propane compartment. There should be some axle grease on those gears. If not I would take some 90 weight axle oil and slowly pour it on the center and let it run down. This purpose is to lubricate the worm shaft which extends and retracts the leg. If you are hooked up to the truck run the legs up and down after lubing both legs. Once you feel they are working better then put a big glob or wheel bearing grease in the top of each leg and put the cap back on.
Here is a photo of leg mechanics.
|
__________________
2010 3150RL
LevelUp, Dual 6 volt batteries, Progressive Industries EMS HW50C, Honda EU2000i Generator, Bridgestone Duravis R250 tires, Torklift Glowstep Revolution Stairs, LED Tail lights
2015 RAM 3500 Laramie SRW LB CC Cummins 6.7L Aisin Trans B&W RVK3600
|