|
The six point Lippert hydraulic leveling system won’t.. in most cases be able to auto level if nose is below a “level” condition when auto level is pressed
The algorithm is... nose dips below 0.0 to find a negative value. This is determined by the front compartment control module AND remote rear sensor located behind last axle.. centered.. up inside on a flat mounting plate... colorplast hides the remote sensor
Once a negative value is found then the unit raises to 0.0 value front to back...
IF during auto level sequence the TWO F/B sensors can’t detect a less than 0 value because unit was already below 0.0 when auto level was started most of the t8me the front of the fifth wheel will continue to lower and error out
To clear error raise front of fifth wheel to just above level in manual mode at re select auto level
All of this is stored in eprom on the front control module....that’s how the system works
|