|
My pic shows you there is a single red wire that plugs into the front fwd controller..
Measure at that red wire to ground .. if you have no 12 vdc there then the level up display will be dead
Also looking at your dual polarity solenoid wiring the retract wire (Yelllow) was moved to what looks like a single spliced non OEM wire on that terminal.
Someone has done a lot of wire changing..
It looks from the picture the yellow wire that should be on the retract side terminal is spliced downstream from that single wire the previous owner used.
If you measure at the dual polarity solenoid on the large red cable and to ground it will read 12 vdc even with system not running if power is applied and the resettable breaker is good
|