View Single Post
Old 11-30-2017, 02:38 PM   #11
JetMech
Established Member
 
Join Date: Nov 2017
Location: Summerville
Posts: 12
M.O.C. #20891
Send a message via AIM to JetMech Send a message via MSN to JetMech Send a message via Yahoo to JetMech
Looks to me like you could unhook on level pad, then level RV. Then measure from the ground to the bottom of the RV near the pin box. Then measure from the ground to the bed rails on your big 4x4. The RV should be about 6 inches higher. If not, add risers to your RV to bring it into the 6 inch clearance parameter. Then backing under the RV, check if you really do need to adjust your pin box. "The taller the truck the taller the RV".

JetMech
JetMech is offline   Reply With Quote