I wanted to install scissor jacks and add another storage tube under the trailer but the factory installed gas line ran under the frame and was in the way. I removed the gas line and modified it so it could be reinstalled on the side of the frame. I removed the front vertical section of the original pipe and replaced it with the rear section of the original pipe. Then I removed one of the two front 90 degree ells and replaced it with a street ell. I then added a street ell where the rear vertical pipe used to be and reinstalled the assembly. New material used-- two street ells. Old material discarded-- long vertical pipe, 90 degree ell and 2 inch nipple. Then I was able to install the jacks. While I was removing the gas line assembly, I found the copper line to the refrigerator was pressed up against the edge of the bracket holding the sewer pipe. This would have worn a hole in the copper, eventually.
http://s572.photobucket.com/albums/s...%20Line%20Mod/