[Montana_2957]

The corner shower in my Mountaineer 315 has always had a fair amount of flex in the front part of the floor by the drain. I recently noticed that the drain is settling. There is a small access panel through bedroom - meaning too small to do anything but look. The shower floor sits on a plywood platform supported by way too few 3.5 inch blocks. As best I can see through the opening,the platform goes to the drain but does not extend in front of the drain. Somehow, I need to fix this before the drain starts to leak. Would appreciate any comments or suggestions. Would obviously not like to remove the shower to correct this poor installation problem. Thanks