Thread: Frame Flex
View Single Post
Old 07-20-2016, 03:37 PM   #4
dieselguy
Montana Master
 
dieselguy's Avatar
 
Join Date: Feb 2005
Location: Haysville
Posts: 4,261
M.O.C. #3085
Measured from the top of the pin box underneath the front cap to the molding around the front cap I get about 1/4" difference from hooked to my truck compared to sitting on the landing gear. I have the same unit as you. It does move a bit more when hitting a real rough bump in the road. No noise when hitching up or unhitching other than perhaps my truck springs moaning a bit. Look at the trim piece running along the fifth wheel wall portion a few inches below your bedroom slide ... if the sealer has pulled loose in that area, you may have an issue. Look close at the staples in your front closet for ones that have pulled clear thru.
dieselguy is offline   Reply With Quote