Thread: Skylight shade
View Single Post
Old 05-05-2010, 02:43 PM   #37
New Member
Join Date: Jan 2007
Posts: 7
M.O.C. #6742
We have a 2955 and there was too much light coming in the skylight so I took some scrap J channel left over from my vinyl siding and cut it slightly longer than the skylight. Then loosen the screws holding the skylight frame and slide the back side of the J channel between the ceiling and frame and tighten the screws back up making a frame into which you can slide a piece of paneling. I used oak paneling as it matches our woodwork and cut it the size made by the J channel and a little longer than the channel. It stays is place even during travel and can be taken part way out for some light or just slide it all the way out when you wish more light. This has worked for us for about 2 years now and it sounds like it might be what your looking for. Hope this helps and good luck.
vampire is offline   Reply With Quote