View Single Post
Old 05-03-2017, 04:17 AM   #19
Phil P
Montana Master
 
Join Date: Mar 2011
Location: Okeechobee
Posts: 2,150
M.O.C. #11206
Hi

Ours didn’t work from the factory. After Keystone refused to do or pay for the needed repairs to make their do-it-yourself kit usable as an RV trailer I started working on the systems that didn’t work.

What I found for all of the tank level indicators except the potable water tank was an incorrect installation of the probes. By relocating the probes in the proper position my indicators now work properly.

Apparently the manufacturer prepares the tanks before installation by placing them on a bench upside down. This results in the probes being installed with the 1/3 level probes in the bottom of the tank instead of 1/3 of the way up from the bottom.

I had to install 2 new probes in all three waste tanks. This corrected the incorrect readings. However you must clean them to remove soap scum etc periodically.

Phil P
Phil P is offline   Reply With Quote