|
I could not think of a short version on how to hook up the control panal, so here goes.
Step 1: I installed Winegards Entertainment Select. Model VS-0503/VS5312.This model has the power for the ant. amplifier
included.I first tapped into a 12v source which was the light over the desk which is next to our TV entertainment
center in our 3670.
Step 2: In the front closet is located the factory installed ant plate with the button to supply power to the ant.The
bedroom TV is connected to the front of it. The first thing I did was throw this plate away. On the back are three
coaxes. One is marked from ant. One is marked cable and the third is marked TV-2. I used a double coax connector and
connected the coax from the ant to the coax marked cable. This put the signal from the ant foward to the single jack
plate in the entertainment center. I took the coax marked TV-2 and connected it to the back of a single TV jack plate
that I used to replace the factory plate in the bedroom. I connected the cable from TV-2 to the front of the new
wall plate. I taped off the 12v wires that had gone to the old wall plate and than taped them to one of the coaxes
so I would not loose them in the wall. This way I can use them if I ever need a 12v source in that area.After
connecting the TV-2 cables, this put TV-2 signal into the top jack on the double jack plate in the entertainment
center.At this time you can throw the loop between the two jacks away.
The lower jack on the double plate is for cable in.I have a sat dish on the roof that is wired direct to my sat
reciever in our entertainment center.Now, all you have to do is hook up the appropriate coax cables to the back ofthe
control center and you have control over your sat signal, cable signal or TV ant signal. Just remember to push in
the power switch when you use the ant.Good Luck Walt
by hooking
|