Quote:
Originally Posted by drschaaf
I don't have a residential fridge, mine runs on propane/ac. To the best of my knowledge I don't have an inverter. I could be wrong, but from other posts I have seen it sounds like there are typically fuses for an inverter on the circuit panel. My panel justs has breakers/fuses for the usual components (see pic).
Just a couple of more notes. The second red cable that has the black heat sink coating on it that's attached to the positive post - is the one that pulled out of its spade that was causing the problems with my jacks to error out, so I'm guessing they are fed directly from the battery via that connection.
The second red cable on the negative post goes back through a hole in the bulkhead. I would have to figure out a way to get at it to see where it goes, but I'm wondering if that might be to complete the circuit for the jacks?
|
I would just disconnect that red wire at the negative post and see what stops working if anything. Then you know where it goes without trying to trace it all over.