Quote:
quote:Originally posted by RADHAZJOE
Ihave inherited a piece of 4 inch PVC, 8 ft long, Any ideas wheretomountit and howto store sewer hose? Do I close off one end with and cap? DoI use a screw on fitting on the other end How doI mount it under Monty ? Thnksto all.
|
I did as Ozz did. I mounted two of these pipes under the rig behind the little flimsy one that comes with the rig. I used collars on both ends with the screw-in caps so that I have access from either side of the rig. I attached them with the same type of self-tapping bolts used on the underbelly of the rig, along with fender washers. I drilled two 3/4" holes on one side of the tubes, then small pilot holes through the top side of the tubes into the frame. From there I was able to screw in the self tappers. These have held very well over the last three years and have proven to be very good places to store those hoses. I also throw in a lot of the loose paraphenalia needed at different times. When I need an extra fitting I "fish" it out using my awning hook.
Orv