I haven't taken any picture of them yet. I am in N.E. Iowa and there is about 18 inches of snow on the ground. I would have to use the skidloader to get to it, as it is parked outside.....Sorry. Maybe I can explain it a little better... On each jack there are two flat support braces. One brace on the front side and one on the back side. They have a bend or brake on the ends of them that has the bolt hole in them. Take a one inch wide angle that is about 1/4 inch thick and weld it on those flats, the length of them from the bend on one end to the bend on the other end. I think those flats are about 18 inches long. Can't remember..... You will notice that you have to weld it on the right side (outword side) so that the braces have clearence to operate properly. I'll see if I can go out and take some pictures ....JB
|