Gee here I am back.
Thanks for the suggestions fellows.
Here is what I have found so far,
Problem #1 No Power on the positive side of the Board on the manual side. there is power going into the board from the input side.
all grounds are good as I fixed them, was some sloppy work on the crimps from factory but now repaired. and checked.
Problem #2
This was puzzling me a bite as there was no power to the visible wires, Well I took the cover off of the thermal couplers and found power on one side of the lower right coupler,
So that led me to believe that it was a bad coupler.
I taped it with handle of my screw driver and Bingo the hot water heater started up. Bad therm o coupler will replace if it happens again.
Now have to go back to problem # 1
Best go get me a sledge Hammer for this one,
R.E.H
|