|
Way back in 2002 I purchased two 8' X 4" pvc pipes, four threaded collars and four screw-in caps. I mounted both of them under the front of the rig behind the front legs. After determining where to drill access holes for mounting the pipes to the RV chassis beams (one on each end of each pipe), I then used 1/4" X 1 1/4" self tapping screws with 1/4" fender washers to hold the pipes to the chassis. Makes it very handy to store the sewer hoses and to access them when getting parked. Make the access holes on the bottom side of the pipes large enough to not only allow access for your drill but to allow any moisture to escape.
I store sewer fittings in one of the pipes also.
Orv
|