|
Carl,
Of course I remember your name! Waht do you think I am, old!
Phil,
Carl's idea is almost exactly what I stole as an idea, after he had posted and sent me the instructions. I do have the instructions pigeon holed somewhere and just need to find them.
As Carl stated, I used aluminum stock because I live on the Gulf Coast of Texas and it's a hassle trying to keep after steel and rust.
Just remember, steel or aluminum, measure twice, cut once.
Also, I did not cut any of the underbelly. Instead, we drilled a hole through it, and the frame rails. All we had to do was take down one side of the underbelly and reach with a long arm. Use blue thread lock and I even used double nuts. If you put it in the middle you will have to most likely cut the underbelly and make a flap as carl did.
Good luck.
|