|
Just had this set-up installed in our 2010 3400RL. The service tech installed a triple LNB dish on a pole. He then attached a solo NODE to the dish and ran a single coax cable from the NODE to our service center. He attached a TAP to the other end of the coax which splits the signal. We have 2 satellite and 1 cable TV inputs in our service center. From the tap he ran a cable to each satellite connection, one to the HOST and one to CLIENT (on the tap), Host is the sat connection for the living room where the Hopper is and client is the one for the bedroom where Joey is. In the closet in bedroom he removed the jumper from the antenna booster and connected it to the satellite feed which completes the circuit to the bedroom TV. Connected the coax from the wall behind the TV to the Joey and an HDMI cable from Joey to the TV. In the living room he ran a cable from the satellite wall jack to the Hopper and ran an HDMI cable from the Hopper to the TV. Everything works just as it did in the house in Kentucky. Tim
|