Montana Owners Club - Keystone Montana 5th Wheel Forum - View Single Post

Ozz · 12-07-2014, 02:47 AM

Thanks Jim,
I use a power tool you can set the depth of the cutter on to just barely cut the wall-board:
http://www.homedepot.com/b/Rotozip/N...ols-_-shop_now
You could cut right where wires are and not cut the wire if you set the depth attachment correctly, but you know they pull the wires down the same wall area where the readout/switch/controller is, so just be careful there.

12-07-2014, 02:47 AM	#6
Ozz Montana Master Join Date: Jul 2006 Location: K.C. Posts: 11,731 M.O.C. #5980	Thanks Jim, I use a power tool you can set the depth of the cutter on to just barely cut the wall-board: http://www.homedepot.com/b/Rotozip/N...ols-_-shop_now You could cut right where wires are and not cut the wire if you set the depth attachment correctly, but you know they pull the wires down the same wall area where the readout/switch/controller is, so just be careful there.