|
I went with the wired camera as have others. Take out one of the center rear clearance lights, the one on the top corner, and one of the tail lights. You can fish tape the wire between these points. You can then go on top of the belly pan the length of the camper to the front storage bay where the hyd pump is. Then run the wire up under the bedroom and out the pin box area somewhere so you can have a pigtail to hook on to the trucks monitor wiring. You'll have to drill a 1/2" hole in the rear cap either above or under the center clearance lights for the coax to connect up to the camera. Seal it with a grommet or RTV. You'll also have to drill another couple of holes to get the wire from the belly pan into the front compartment. It takes a little while, but the end product is better than stringing the wire on the exterior somehow and grabbing a roll of tape. The previous sentence in just my personal opinion and not meant to diss any other install.
|