[desertdog]

OK, So I finished packing all four sets of bearings. Two of them had the rear seal blown. The grease went everywhere on the back plates. I replaced the two back plates. Found a Dexter dealer, and bought the completed back plate with all brake parts pre assembled. The bearings and races all looked good so I just repacked them replaced all seals and dust caps as well.

Next I ordered and installed new wet bolts, bronze bushings, Cams, and lock nuts for the missing ones. Finally I greased all of the supension wet bolts.

Yesterday, I took the rig in for an alignment. good thing I did as it was out by quite abit.
Feeling good about the setup. Thanks for everyones advice and knowledge share.