Quote:
Originally Posted by Hblick48
I had my main slide hydraulic cylinder rebuilt, and re-installed it a few weeks ago. I read the Lippert instructions, and they are exactly how I did mine. Much easier on the pump to bleed the system before putting a load on it.
|
How did you get the slide out cylinder rebuilt? Asking because on my older unit the ends are welded on.. these are the older steel cylinders.. the newer ones out now are aluminum and the ends are alse welded on..
Looking at the Rod end it appears "I think" that there is a screw on silver end cap with hydraulic fitting but not sure... If so I would assume this end unscrews so the entire guts can be removed and seals replaced?
What was your cost to get your slide out cylinder rebuilt?