So I got the borescope and it was a piece of junk. The underbelly is too dark to see anything. However, I did find the beam with the rear sensor attached to it and it was solid. I unplugged the cable from the sensor and it seemed well connected. I reattached and retracted the rears and then raise the front. Autolevel worked fine and brought it back level.
Maybe the sensor is intermittent. I did find out that with the rear sensor unplugged you get an error on the control panel.
At this point I'm going to tape up the holes I made and live with it the next few trips out.
I hate to spend $219 on a new sensor not knowing if that is the problem.
__________________
Jim & Martha Abernathy
2014 Montana 3402RL Level UP, Sailun S637's, TST 507, 500W solar
2014 Ram 3500 Laramie® 4x2 diesel dually crew-cab 3.73 axle, Reese R20
|