Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > Search Forums
Click Here to Login

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: jcurtis934
Forum: General Discussions about our Montanas 11-27-2018, 08:32 PM
Replies: 8
Views: 501
Posted By jcurtis934
Never trusting the rig to bare vents, I put max...

Never trusting the rig to bare vents, I put max aire covers on both vents and don't have to worry.
Forum: Maintenance 11-22-2018, 11:13 AM
Replies: 7
Views: 569
Posted By jcurtis934
Bummer about how they designed your system. I...

Bummer about how they designed your system. I would think that you could remove the valve and bolt the flanges together if you made a custom rubber gasket to fit in between. Should be easy to make it...
Forum: General Discussions about our Montanas 11-21-2018, 01:47 PM
Replies: 34
Views: 1,498
Posted By jcurtis934
Common ducts for both ac units.

Common ducts for both ac units.
Forum: Montana Problems, Problem Solving & Technical Help 11-19-2018, 10:47 AM
Replies: 8
Views: 588
Posted By jcurtis934
I would remove the two screws in the rail on the...

I would remove the two screws in the rail on the rig side, then cycle a few times before putting them back in. Can't hurt. I agree with you that it is time to replace the awning again though.
Forum: Maintenance 11-14-2018, 01:12 PM
Replies: 12
Views: 884
Posted By jcurtis934
You may have to raise the trailer on the levelers...

You may have to raise the trailer on the levelers to get grease to flow, just raise on side to lift tires and then the other. I make the assumption that bad zeros weren't installed...
Forum: Practice and Testing Forum 11-14-2018, 01:09 PM
Replies: 8
Views: 800
Posted By jcurtis934
Mine also started to go south on the front...

Mine also started to go south on the front button, so it was e trailer for us. You will get the new updated panel, but it works just fine on the system.
Forum: General Discussions about our Montanas 08-30-2018, 10:30 AM
Replies: 27
Views: 1,762
Posted By jcurtis934
I think the major issue with rv ovens is that...

I think the major issue with rv ovens is that they heat well below what the gas know indicates and use of an accurate thermometer is needed to understand what temperature it is at for any baking job....
Forum: Montana Problems, Problem Solving & Technical Help 08-30-2018, 10:22 AM
Replies: 7
Views: 715
Posted By jcurtis934
Not hard to drop bottom mrkaraoke. If that task...

Not hard to drop bottom mrkaraoke. If that task is more than you can do, then anything wrong inside will be beyond you as well and you should get a mobile repair or dealer to fix.
Forum: General Discussions about our Montanas 08-28-2018, 10:34 AM
Replies: 6
Views: 361
Posted By jcurtis934
The other difference is the water outlets into...

The other difference is the water outlets into the bowl. 320 pretty much directly vertical flow, 310 does a slightly sideways flow of water to rinse bowl. At least that is the way they were a couple...
Forum: Campgrounds 08-24-2018, 08:53 AM
Replies: 12
Views: 614
Posted By jcurtis934
Assume you have contacted parks in florida and...

Assume you have contacted parks in florida and have reservations...
Forum: General Discussions about our Montanas 08-23-2018, 05:36 PM
Replies: 22
Views: 1,247
Posted By jcurtis934
The outer edges of the roof running front to back...

The outer edges of the roof running front to back are sheet metal under the rubber roof material and has no support under it.
Forum: Maintenance 08-23-2018, 05:11 PM
Replies: 22
Views: 1,472
Posted By jcurtis934
The tanks aren't bolted down. They sit on two...

The tanks aren't bolted down. They sit on two metal rails at the top outward flange of the tank. Whether the tank has support under the tanks per the tank manufacturer is highly unlikely as keystone...
Forum: General Discussions about our Montanas 08-23-2018, 04:57 PM
Replies: 22
Views: 1,247
Posted By jcurtis934
That is a good shot of a roof truss. Notice that...

That is a good shot of a roof truss. Notice that no plastic grommet was used to "line" the holes in the truss to protect the wires from eventually/maybe being a Braden by the sharp edge of the truss....
Forum: Montana Problems, Problem Solving & Technical Help 08-23-2018, 04:48 PM
Replies: 9
Views: 555
Posted By jcurtis934
The "blockage" is probably no more than one of...

The "blockage" is probably no more than one of the 12vdc controlled actuators (valves) that pull back a needle valve to allow hydraulic fluid to flow from the manifold and into the appropriate...
Forum: Additions & Improvements 08-21-2018, 11:35 AM
Replies: 16
Views: 1,177
Posted By jcurtis934
Your neighbors would probably appreciate you...

Your neighbors would probably appreciate you arriving in the day light more than after dark, especially midnite. And it makes things a lot easier...
Forum: Montana Problems, Problem Solving & Technical Help 08-21-2018, 11:29 AM
Replies: 37
Views: 1,389
Posted By jcurtis934
Yes on the covers. And if putting monte in...

Yes on the covers. And if putting monte in storage lot...always disconnect the negative cable that grounds out to chassis.
Forum: New Member Introductions 08-19-2018, 07:28 PM
Replies: 21
Views: 1,759
Posted By jcurtis934
Sounds like a good deal to me. Enjoy.

Sounds like a good deal to me. Enjoy.
Forum: Montana Problems, Problem Solving & Technical Help 08-19-2018, 07:25 PM
Replies: 18
Views: 704
Posted By jcurtis934
What bbtx was saying is that pigtail of trailer...

What bbtx was saying is that pigtail of trailer in hand and use a piece of wire to supply battery power to different lights to see what works or not.
Forum: Tow Vehicles & Towing 08-18-2018, 11:01 AM
Replies: 6
Views: 332
Posted By jcurtis934
So for a trailer such as the swivel maxing out at...

So for a trailer such as the swivel maxing out at 600#, that translates to 60# on the montana hitch. Certainly within the limits of the hitch. What I don't know about is whether this would be...
Forum: Montana Problems, Problem Solving & Technical Help 08-17-2018, 10:50 AM
Replies: 9
Views: 410
Posted By jcurtis934
Sorry that I read your post as non self priming....

Sorry that I read your post as non self priming. If the pump you put in has a mesh filter attached, you want to make sure the o ring is installed and filter hand tight. If the pump has push in...
Forum: Montana Problems, Problem Solving & Technical Help 08-16-2018, 10:21 AM
Replies: 9
Views: 410
Posted By jcurtis934
Non self priming pumps are a major pain and only...

Non self priming pumps are a major pain and only meant to be used where pump is lower than the water tank feed line. Obviously not meant for typical fifth wheel environment and I would suggest you...
Forum: New Member Introductions 08-16-2018, 10:11 AM
Replies: 52
Views: 2,560
Posted By jcurtis934
The key thing is a good dealer that does a proper...

The key thing is a good dealer that does a proper inspection when they get a unit from the factory and fixes all the issues prior to you inspecting and then signing papers. Crappy dealer, crappy unit...
Forum: Montana Problems, Problem Solving & Technical Help 08-16-2018, 09:58 AM
Replies: 5
Views: 346
Posted By jcurtis934
Yes, the tanks have a molded in number on them....

Yes, the tanks have a molded in number on them. Had two breaks on our galley tank, the top rim split and the bottom cracked. Plastimend repair still as good as the day I did it. Galley tanks are...
Forum: MOC Rig Registry Discussions 08-16-2018, 09:46 AM
Replies: 5
Views: 468
Posted By jcurtis934
Welcome to the group. Hope you enjoy your unit.

Welcome to the group. Hope you enjoy your unit.
Forum: Montana Problems, Problem Solving & Technical Help 08-13-2018, 10:32 AM
Replies: 12
Views: 1,424
Posted By jcurtis934
I have yet to hear of any keystone rv with the...

I have yet to hear of any keystone rv with the galley tank pull in the center...exception would be rear bedroom/front living room, but we are talking about keystone.
Showing results 1 to 25 of 500

 
Forum Jump
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 05:32 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.