Forum: Montana Problems, Problem Solving & Technical Help
04-14-2024, 04:01 PM
|
Replies: 6
Views: 817
Out of stroke error is caused when the leveler...
Out of stroke error is caused when the leveler leg extends its full length and the front forward controll doesn’t see any change in degree of level
Use blocks under the leveler legs to prevent...
|
Forum: Maintenance
04-12-2024, 07:27 AM
|
Replies: 5
Views: 639
I dont use any liquid ... I use my air hose at...
I dont use any liquid ... I use my air hose at low psi and blow out the condenser coil..
The Evap area is where the gateway is tucked away at down just inside the duct ... I would not want liquid...
|
Forum: Montana Problems, Problem Solving & Technical Help
04-10-2024, 07:36 AM
|
Replies: 7
Views: 334
|
Forum: Montana Problems, Problem Solving & Technical Help
04-10-2024, 07:32 AM
|
Replies: 7
Views: 334
Newer GMC trucks have often had issues when...
Newer GMC trucks have often had issues when connected to an RV.. There are many post out there regarding the issue... Usually truck problem.
Your truck is brand new so the 7 way connector should...
|
Forum: Maintenance
04-05-2024, 07:05 AM
|
Replies: 10
Views: 1,782
|
Forum: General Discussions about our Montanas
04-05-2024, 07:03 AM
|
Replies: 23
Views: 2,639
It was High hitched.
You did the pull test...
It was High hitched.
You did the pull test and stated you walked around visually inspecting things before departure.
But. Did you go behind the truck and look at the kingpin and jaws with a...
|
Forum: Maintenance
03-31-2024, 07:41 AM
|
Replies: 10
Views: 1,782
Dexter recommends clean, inspect and repack...
Dexter recommends clean, inspect and repack bearings every 12K miles or annually.
The quality of the grease is important . I use Lucas Red & Tacky grease.. My bearings are now 11 years old (...
|
Forum: General Discussions about our Montanas
03-24-2024, 12:03 PM
|
Replies: 7
Views: 721
Ive not had any cooling issues with my 1350RM...
Ive not had any cooling issues with my 1350RM fridge. It is stock.. 11th year of use.. mounted in a slide out.
Video from my YouTube channel... https://youtu.be/P-caUemL-Ig?si=2E9gDiI-lL40yYTM
...
|
Forum: Montana Problems, Problem Solving & Technical Help
03-24-2024, 08:35 AM
|
Replies: 25
Views: 1,301
|
Forum: General Discussions about our Montanas
03-24-2024, 08:23 AM
|
Replies: 7
Views: 721
I would be checking to verify you have 12 vdc...
I would be checking to verify you have 12 vdc coming off that relay I’ve indicated with a red arrow.
12 Vdc is fed directly from the control panel incoming 12 vdc source over to that relay..
...
|
Forum: Tow Vehicles & Towing
03-23-2024, 06:29 AM
|
Replies: 39
Views: 7,620
|
Forum: Montana Problems, Problem Solving & Technical Help
03-17-2024, 07:34 AM
|
Replies: 7
Views: 979
I operate my hydraulic slides when temps are...
I operate my hydraulic slides when temps are below freezing...and have for the last 10 years on my current unit.. The slides move a bit slower when cold due to fluid viscosity being thicker. BUT THEY...
|
Forum: Montana Problems, Problem Solving & Technical Help
03-16-2024, 07:48 AM
|
Replies: 7
Views: 979
I wonder when the last time was you swapped out...
I wonder when the last time was you swapped out the fluid in the pump reservoir.. There are NO FILTERS in the hyd system so as time goes on and the cylinder rod seals wear, minute particles start to...
|
Forum: Maintenance
03-16-2024, 07:39 AM
|
Replies: 11
Views: 1,339
|
Forum: General Discussions about our Montanas
03-12-2024, 07:28 AM
|
Replies: 13
Views: 1,890
|
Forum: General Discussions about our Montanas
03-05-2024, 07:21 AM
|
Replies: 13
Views: 1,186
AGMS are a nice upgrade for some because they...
AGMS are a nice upgrade for some because they require NO servicing.. I prefer GC2 batteries.. two of these outperform most any other and last many years.. Mine are currently 8 years old
Lithium is...
|
Forum: Montana Problems, Problem Solving & Technical Help
02-23-2024, 07:33 AM
|
Replies: 17
Views: 1,199
|
Forum: Repairs & Service
02-20-2024, 07:39 AM
|
Replies: 16
Views: 1,852
|
Forum: Maintenance
02-17-2024, 07:41 AM
|
Replies: 3
Views: 698
|
Forum: Repairs & Service
02-16-2024, 07:38 AM
|
Replies: 16
Views: 2,662
|
Forum: Montana Problems, Problem Solving & Technical Help
02-09-2024, 03:18 PM
|
Replies: 0
Views: 297
In Command NCSPHB Control Box Info
For some 2021 and newer Montana units the hydraulic slides are controlled via an interface with the BCM.. if this interface experiences excessive current draw the interface is prone to fail
A...
|
Forum: Montana Problems, Problem Solving & Technical Help
02-08-2024, 08:01 AM
|
Replies: 35
Views: 7,994
|
Forum: Maintenance
01-31-2024, 06:49 AM
|
Replies: 2
Views: 689
|
Forum: Montana Problems, Problem Solving & Technical Help
01-23-2024, 10:05 AM
|
Replies: 15
Views: 1,395
IF you hear a "Click" from the dual polarity...
IF you hear a "Click" from the dual polarity solenoid -- its mounted on the pump motor but no pump rotation then I would:
.. check for loose/corroded battery connections and battery voltage
.. If...
|
Forum: Repairs & Service
01-15-2024, 06:08 AM
|
Replies: 32
Views: 2,656
|