Forum: Repairs & Service
08-19-2013, 03:02 PM
|
Replies: 5
Views: 870
Blackwater dump valve
Opening the blackwater dump valve is becoming very difficult and I am concerned that the cable will break. The mechanism seems to be secured between two fanges which are bonded to the drain pipe...
|
Forum: General Discussions about our Montanas
01-02-2013, 01:34 PM
|
Replies: 35
Views: 11,283
|
Forum: Montana Problems, Problem Solving & Technical Help
10-24-2012, 09:45 AM
|
Replies: 22
Views: 1,741
|
Forum: General Discussions about our Montanas
10-24-2012, 09:33 AM
|
Replies: 10
Views: 911
|
Forum: General Discussions about our Montanas
10-24-2012, 09:15 AM
|
Replies: 10
Views: 911
|
Forum: General Discussions about our Montanas
10-10-2012, 01:52 PM
|
Replies: 17
Views: 2,616
The only way to check them is to remove the...
The only way to check them is to remove the bolts. To do this jack the chassis up till the wheels just lift. Then jack the axle up to just remove the weight from the suspension. The bolts can be...
|
Forum: Montana Problems, Problem Solving & Technical Help
10-08-2012, 01:56 PM
|
Replies: 7
Views: 724
|
Forum: Montana Problems, Problem Solving & Technical Help
10-06-2012, 08:42 AM
|
Replies: 7
Views: 724
Kitchen Faucet- Help Needed
After 3 years the kitchen fauucet in my 09 3075 has become badly corroded and leaks. I would like to replace it and have purchased a Moen. However the connections on the new faucet are female and...
|
Forum: Tow Vehicles & Towing
09-26-2012, 02:55 PM
|
Replies: 19
Views: 1,354
|
Forum: Montana Problems, Problem Solving & Technical Help
09-26-2012, 02:41 PM
|
Replies: 22
Views: 1,741
Success-sort of.By using a stronger light I was...
Success-sort of.By using a stronger light I was able to see a small part of the valve and so was able to determine its location relative to the shower taps. Once the panel securing the shower taps...
|
Forum: Montana Problems, Problem Solving & Technical Help
09-26-2012, 07:11 AM
|
Replies: 22
Views: 1,741
Thanks for the ideas. I'm heading out to the...
Thanks for the ideas. I'm heading out to the trailer now so will see. The damage is my fault as I hooked into a supply line at the dump station without attaching a pressure control valve. I always do...
|
Forum: Montana Problems, Problem Solving & Technical Help
09-26-2012, 04:54 AM
|
Replies: 22
Views: 1,741
Black Tank Flush Line Leaking-Help
When I use the black tank flush, water pours out under the sliding door. It is likely a damaged check valve. I need help in locating this valve in my Monty 3075. I have removed the shower taps but...
|
Forum: General Discussions about our Montanas
07-15-2012, 01:45 PM
|
Replies: 21
Views: 3,237
I have never covered my trailers in the past. I...
I have never covered my trailers in the past. I had a friend who did and he found that in a wind the cover chafed against the sides and end caps causing unwelcome wear no matter how well he secured...
|
Forum: General Discussions about our Montanas
07-09-2012, 10:35 AM
|
Replies: 43
Views: 5,856
This AM I decided to try greasing my wheel...
This AM I decided to try greasing my wheel bearings using the recommended method for the EasyLube system- two squirts. As there has been so much discussion as to how effective this system is I...
|
Forum: Maintenance
07-09-2012, 09:55 AM
|
Replies: 13
Views: 1,648
After having a wet bolt kit instsalled I was...
After having a wet bolt kit instsalled I was unable to get grease to flow into the bushings. Even with the chassis jacked up to remove the pressure on the bolts it was a real struggle to get the...
|
Forum: General Discussions about our Montanas
07-05-2012, 12:29 PM
|
Replies: 35
Views: 1,506
|
Forum: Montana Problems, Problem Solving & Technical Help
05-18-2012, 02:51 PM
|
Replies: 8
Views: 884
When I disconnect the hose from the flush...
When I disconnect the hose from the flush connection in the convenience centre, water flows back out. I found that the check valve is not located at the connection but seems to be located somewhere...
|
Forum: Montana Problems, Problem Solving & Technical Help
04-19-2012, 10:02 AM
|
Replies: 1
Views: 907
Red Propane Regulator
Although this topic has been discussed before I feel it is a safety issue and so of interest to new members. Upon opening the door side propane tank (the one with the red regulator) I could hear a...
|
Forum: Tow Vehicles & Towing
04-19-2012, 09:45 AM
|
Replies: 33
Views: 3,481
I have towed 16k miles with my 2011 F350 and...
I have towed 16k miles with my 2011 F350 and smile every time I fire it up. It is quiet and strong with a smooth operating transmission. With speed control set it hums along rarely needing to...
|
Forum: General Discussions about our Montanas
04-15-2012, 04:07 PM
|
Replies: 8
Views: 1,238
|
Forum: Additions & Improvements
03-20-2012, 04:07 AM
|
Replies: 13
Views: 1,847
|
Forum: Additions & Improvements
03-19-2012, 03:45 AM
|
Replies: 13
Views: 1,847
Kitchen Faucet
After only three years my kitchen faucet looks 20 years old. In addition the handle is loose and I cannot turn the hex screw to secure it. I plan to replace it with one from Home Depot. I am...
|
Forum: Montana Problems, Problem Solving & Technical Help
03-07-2012, 03:07 AM
|
Replies: 13
Views: 2,461
|
Forum: General Discussions about our Montanas
02-29-2012, 04:24 AM
|
Replies: 13
Views: 1,135
I felt that there was about 20% of the furnace...
I felt that there was about 20% of the furnace heat output going below to the tanks based on the pipe area. Since we seldom are in below freezing temps I built a diverter box which fits under the...
|
Forum: Montana Problems, Problem Solving & Technical Help
01-13-2012, 01:08 PM
|
Replies: 16
Views: 1,494
I have used the Plasti Mend and have found it...
I have used the Plasti Mend and have found it works well. My leak was at the top of the galley tank where the drain from the sink enters the tank. While I had the belly off I added two braces to try...
|