Forum: Montana Problems, Problem Solving & Technical Help
04-19-2024, 07:24 PM
|
Replies: 5
Views: 938
|
Forum: Montana Problems, Problem Solving & Technical Help
04-18-2024, 02:09 PM
|
Replies: 5
Views: 938
|
Forum: Montana Problems, Problem Solving & Technical Help
04-17-2024, 10:47 PM
|
Replies: 5
Views: 938
Landing gear zirks
Hi, I have a 2017 310 HC Ground control 3.0
I lowered the front all the way down 4th hole on the inner leg to wax my front cap,rear landing gear was up
After waxing cap I brought the front back...
|
Forum: Montana Problems, Problem Solving & Technical Help
07-18-2022, 09:35 PM
|
Replies: 5
Views: 1,306
|
Forum: Montana Problems, Problem Solving & Technical Help
07-17-2022, 10:29 PM
|
Replies: 5
Views: 1,306
|
Forum: Montana Problems, Problem Solving & Technical Help
07-17-2022, 09:28 PM
|
Replies: 5
Views: 1,306
Roof Repair
Went to clean my roof today and found the dicor separating from the cap, I plan on cleaning existing dicor which seems to be in good shape and cover the seam with lap sealant. Question: would I be...
|
Forum: Montana Problems, Problem Solving & Technical Help
06-14-2020, 04:25 PM
|
Replies: 3
Views: 937
Great tips!
Thank you Creeker for the Great info and your fast response.
Snap switch is what I was looking for and I also found the 12 volt block that the existing fans are wired into, project is a snap...
|
Forum: Montana Problems, Problem Solving & Technical Help
06-14-2020, 02:55 PM
|
Replies: 3
Views: 937
Refridgerator fan blocked?
Two Questions
1) I’m adding a cooling fan to the lower portion of fridge to aid in cooling,I’m planning on tying into factory fans behind freezer has anyone tried this?
2) I included a picture...
|
Forum: Additions & Improvements
09-22-2019, 11:59 AM
|
Replies: 8
Views: 2,155
|
Forum: Additions & Improvements
09-22-2019, 11:26 AM
|
Replies: 5
Views: 2,479
Exterior vent for range
2017 310 RE......Our range Exhaust is ducted to the inside,I would like to duct to the outside.Has anyone made this mod a DIY or had it done? There is cabinet space right above the micro so I’m...
|
Forum: Montana Problems, Problem Solving & Technical Help
10-26-2018, 06:46 PM
|
Replies: 17
Views: 6,367
Hi ken,
Glad you had good results with the...
Hi ken,
Glad you had good results with the slide,which dry lube did you use?
My dealer called today said the slide is smooth as silk now,He said they adjusted the cables and used a Baby powder...
|
Forum: Full Timing in your Montana
10-26-2018, 06:54 AM
|
Replies: 19
Views: 5,301
Gave me a laugh thanks,As I live in the big RV...
Gave me a laugh thanks,As I live in the big RV state of Oregon our local Walmart gives us many double looks sometimes!
This is a Great forum for an RV owner,Specifically Montana.
I Get much needed...
|
Forum: Montana Problems, Problem Solving & Technical Help
10-17-2018, 08:24 PM
|
Replies: 17
Views: 6,367
|
Forum: Additions & Improvements
10-15-2018, 03:13 PM
|
Replies: 13
Views: 2,469
As Carl stated above on the abbreviations is...
As Carl stated above on the abbreviations is correct,if your asking what it does it basically protects the electronics in your RV from an electrical surge,like a surge protector on your home...
|
Forum: Montana Problems, Problem Solving & Technical Help
10-12-2018, 04:32 PM
|
Replies: 17
Views: 6,367
Hi pocketlake
Yes that’s the same Zep makes 3...
Hi pocketlake
Yes that’s the same Zep makes 3 different lubricants Dual Force is what I used.
Lots of input on this site,what works for some not so much for others,I read as much as I can then make...
|
Forum: Montana Problems, Problem Solving & Technical Help
10-09-2018, 06:02 PM
|
Replies: 17
Views: 6,367
|
Forum: Montana Problems, Problem Solving & Technical Help
10-02-2018, 12:44 PM
|
Replies: 17
Views: 6,367
|
Forum: Montana Problems, Problem Solving & Technical Help
10-02-2018, 06:10 AM
|
Replies: 17
Views: 6,367
Jumping Slide
Hi fellow RVrs
Had some warranty work done last week on my 2017 310RE dinette/recliner slider as it was not pulling in smoothly.
Less then a week later it’s pulling in rough again,after reading...
|
Forum: Additions & Improvements
09-30-2018, 01:13 PM
|
Replies: 13
Views: 2,469
Thank you everyone for your reply’s,I’m not...
Thank you everyone for your reply’s,I’m not really lazy in fact just the opposite.
Took another look and managed to slide some 2x2s under the EMS for a much more secure mount.
I ran the cord for...
|
Forum: Additions & Improvements
09-28-2018, 09:45 PM
|
Replies: 13
Views: 2,469
Call me Lazy
Hi fellow Montana owners
Installed my progressive 50 EMS today behind the fuse panel,seems to be working fine but here is my question.I really just stuffed it back in there at an angle about 5...
|
Forum: General Discussions about our Montanas
09-24-2018, 05:37 AM
|
Replies: 12
Views: 6,016
|
Forum: Tow Vehicles & Towing
07-16-2018, 08:40 AM
|
Replies: 62
Views: 8,663
I have a 17 Montana HC w/ a Husky hitch and...
I have a 17 Montana HC w/ a Husky hitch and slider.
I tow with a Chevy Duramax standard bed.I have never used the slider but it’s good to know it’s there if needed. I’ve backed in to nearly 90 deg...
|
Forum: Additions & Improvements
04-25-2018, 10:16 PM
|
Replies: 4
Views: 1,271
|
Forum: Additions & Improvements
04-21-2018, 09:53 AM
|
Replies: 8
Views: 1,710
Hi and thank you sir,
Yes I installed valve...
Hi and thank you sir,
Yes I installed valve first Then wrapped new valve where it twist on and then onto existing pipe.I cut the tape in 12in strips to make it easier as the tape has a peel off...
|
Forum: Additions & Improvements
04-21-2018, 08:10 AM
|
Replies: 8
Views: 1,710
Valterra
I’m not sure what qualifies me to twist on a valve,but I can rebuild an engine so I’m pretty confident that I twisted it on right but thanks for the reply.
Also I thought about using a screw but I...
|