Montana Owners Club - Keystone Montana 5th Wheel Forum

Montana Owners Club - Keystone Montana 5th Wheel Forum (http://www.montanaowners.com/forums/index.php)
-   Maintenance (http://www.montanaowners.com/forums/forumdisplay.php?f=142)
-   -   She won't take grease (http://www.montanaowners.com/forums/showthread.php?t=75039)

leemedic 08-12-2018 02:03 PM

She won't take grease
 
I have one wet bolt that just will not take any grease. I have taken all the weight off the axel, I have placed a wrench on the bolt and she spins easily, I have replaced the zerk fitting, and for the life of me I cannot get grease in the bolt.

I am sure someone out there has an answer. :popcorn:

AZ Traveler 08-12-2018 02:08 PM

Pull the bolt out, check that the hole is open, put some grease on it and then try again after reinstalling or just buy a new bolt and replace while you have it apart.

leemedic 08-12-2018 02:45 PM

I got her greased. I slowly rotated the bolt from the back side until she accepted the grease. I read the hole in the bolt should be at a certain position.

Golfmedik 08-12-2018 08:55 PM

I had to do the same thing with one of mine. Made sure the hole was turned to the 3 or 9 o'clock position before it would take it.

dieselguy 08-12-2018 09:12 PM

Technically the bolt should not be able to spin in the spring hanger. The bolts are serrated to hold them in the installed location. The better way is to drive the bolt back out, clock it correctly and drive it back in with a brass or aluminum drift … or pull it back in the hanger with the nut. Similar serrations as on wheel studs.


All times are GMT -6. The time now is 05:56 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.